|
123456789101112131415161718192021222324252627282930313233343536373839404142434445464748495051525354555657585960616263646566676869707172737475767778798081828384858687 |
- #include "EasyTransfer.h"
-
-
-
-
- //Captures address and size of struct
- void EasyTransfer::begin(uint8_t * ptr, uint8_t length, Stream *theStream){
- address = ptr;
- size = length;
- _stream = theStream;
-
- //dynamic creation of rx parsing buffer in RAM
- rx_buffer = (uint8_t*) malloc(size+1);
- }
-
- //Sends out struct in binary, with header, length info and checksum
- void EasyTransfer::sendData(){
- uint8_t CS = size;
- _stream->write(0x06);
- _stream->write(0x85);
- _stream->write(size);
- for(int i = 0; i<size; i++){
- CS^=*(address+i);
- _stream->write(*(address+i));
- }
- _stream->write(CS);
-
- }
-
- boolean EasyTransfer::receiveData(){
-
- //start off by looking for the header bytes. If they were already found in a previous call, skip it.
- if(rx_len == 0){
- //this size check may be redundant due to the size check below, but for now I'll leave it the way it is.
- if(_stream->available() >= 3){
- //this will block until a 0x06 is found or buffer size becomes less then 3.
- while(_stream->read() != 0x06) {
- //This will trash any preamble junk in the serial buffer
- //but we need to make sure there is enough in the buffer to process while we trash the rest
- //if the buffer becomes too empty, we will escape and try again on the next call
- if(_stream->available() < 3)
- return false;
- }
- if (_stream->read() == 0x85){
- rx_len = _stream->read();
- //make sure the binary structs on both Arduinos are the same size.
- if(rx_len != size){
- rx_len = 0;
- return false;
- }
- }
- }
- }
-
- //we get here if we already found the header bytes, the struct size matched what we know, and now we are byte aligned.
- if(rx_len != 0){
- while(_stream->available() && rx_array_inx <= rx_len){
- rx_buffer[rx_array_inx++] = _stream->read();
- }
-
- if(rx_len == (rx_array_inx-1)){
- //seem to have got whole message
- //last uint8_t is CS
- calc_CS = rx_len;
- for (int i = 0; i<rx_len; i++){
- calc_CS^=rx_buffer[i];
- }
-
- if(calc_CS == rx_buffer[rx_array_inx-1]){//CS good
- memcpy(address,rx_buffer,size);
- rx_len = 0;
- rx_array_inx = 0;
- return true;
- }
-
- else{
- //failed checksum, need to clear this out anyway
- rx_len = 0;
- rx_array_inx = 0;
- return false;
- }
-
- }
- }
-
- return false;
- }
|