/* Stereo peak meter example, assumes Audio adapter but just uses terminal so no more parts required.

This example code is in the public domain
*/

#include <Audio.h>
#include <Wire.h>
#include <SPI.h>
#include <SD.h>

const int myInput = AUDIO_INPUT_LINEIN;
// const int myInput = AUDIO_INPUT_MIC;

AudioInputI2S        audioInput;         // audio shield: mic or line-in
AudioAnalyzePeak     peak_L;
AudioAnalyzePeak     peak_R;
AudioOutputI2S       audioOutput;        // audio shield: headphones & line-out

AudioConnection c1(audioInput,0,peak_L,0);
AudioConnection c2(audioInput,1,peak_R,0);
AudioConnection c3(audioInput,0,audioOutput,0);
AudioConnection c4(audioInput,1,audioOutput,1);

AudioControlSGTL5000 audioShield;


void setup() {
  AudioMemory(6);
  audioShield.enable();
  audioShield.inputSelect(myInput);
  audioShield.volume(0.5);
  Serial.begin(9600);
}

// for best effect make your terminal/monitor a minimum of 62 chars wide and as high as you can.

elapsedMillis fps;
uint8_t cnt=0;

void loop() {
  if(fps > 24) {
    if (peak_L.available() && peak_R.available()) {
      fps=0;
      uint8_t leftPeak=peak_L.read() * 30.0;
      uint8_t rightPeak=peak_R.read() * 30.0;

      for(cnt=0;cnt<30-leftPeak;cnt++) {
        Serial.print(" ");
      }
      while(cnt++<30) {
        Serial.print("<");
      }
      Serial.print("||");
      for(cnt=0;cnt<rightPeak;cnt++) {
        Serial.print(">");
      }
      while(cnt++<30) {
        Serial.print(" ");
      }
      Serial.println();
    }
  }
}