Migrating the half duplex support I did in the Stagnant and out of date PR to enhance Uarts: https://github.com/PaulStoffregen/cores/pull/419

To try to support Half duplex mode in a similar way like we do for RS485 like support.

With T3.x made use of bitband address for the TX Direction setting, so
Except for the begin which calls format, no code changed, we simply stored the bitband address of the TXDIR flag into the TXDIR variable that was already used for the set direction flag.

For T4.x - it is a little more work as there is no bitband support on M7 processors.  For GPIO there is a Set and Clear register which we use, but for the appropriate UART register there is no such setup of registers.  So I have to special case we are in that mode and do it... Also since not atomic I cli/sei...

Serial Half Duplex - Fix T4Serial1 and T-LC Serial1-3

Updates: T4
T4 Serial 1 did not have proper settings for IOMUXC_LPUART6_TX_SELECT_INPUT

Tested T4.1 Serial1-8

Tested T3.5 Serial1-6

T3.6 - Added support for LPUART which is Serial6 which now works.

T-LC
Make half duplex work on T-LC on Serials1-3

Tested on on T3.5 1-6

I forgot to remove the default eventhandlers from some of the HardwareSerial files as such the ones in the serialEventX files was not used and why my flags were not set properly.

Could have done simple fix, but decide to make it more consistent with what I did in T3.x/LC code and not look through all the NULLS, but simply have list of active ones and count of active.

Appears to fix the issue so far.

Found a way that appears to work to detect if a sketch has our default serialEvantX functions, and that the users code has not implemented their own.  Before on SerialX.begin() I would add that serial ports code to table of function calls to do the if SerialX.available() call serialEvernt..

But I now have a hacked up version where each of the event functions are in their own source file, along with a variable that is defined.  Elsewhere I have those same variables defined with an attribute of ((weak)), so if our default implemention is pulled in it is defined with a value of 1, if the weak version is used because the user has their own implemention, then  it is defined as a 0... So I can detect this at the begin method and only add the code to do the checks in yield if the user implemented it.

WARNING this also brought in changes for using XBar pins for CTS and RX pins... As I did not wish to split back out and have you maybe have to manually merge.

A few of the T4 and now T4.1 Serial ports support a CTS pin.  One was previous fixed, added the others to tables.

Also T4.1 has Some Serial port pins in the area that the optional memory chips could be installed

Found some of our code has these defined, plus had in another test sketch so defined them hopefully with C bindings, but calls Serial1 object code

Add some support for serialEventX calls when yield is called.

Currently keep table of which SerialX objects are Used (.begin called) and each has their own function which does the
if (Serial1.available()) serialEvent1();

Calling SerialX.end(), removes the call from the list.  Also the default weak pointer serialEventX functions call the disable function, as to only be called once as no one is actually processing them...

At some point will integrate this with EventResponder

Hopefully will be able to get this such that only those objects that are used will be brought in by the system...