Migrating the half duplex support I did in the Stagnant and out of date PR to enhance Uarts: https://github.com/PaulStoffregen/cores/pull/419

To try to support Half duplex mode in a similar way like we do for RS485 like support.

With T3.x made use of bitband address for the TX Direction setting, so
Except for the begin which calls format, no code changed, we simply stored the bitband address of the TXDIR flag into the TXDIR variable that was already used for the set direction flag.

For T4.x - it is a little more work as there is no bitband support on M7 processors.  For GPIO there is a Set and Clear register which we use, but for the appropriate UART register there is no such setup of registers.  So I have to special case we are in that mode and do it... Also since not atomic I cli/sei...

Serial Half Duplex - Fix T4Serial1 and T-LC Serial1-3

Updates: T4
T4 Serial 1 did not have proper settings for IOMUXC_LPUART6_TX_SELECT_INPUT

Tested T4.1 Serial1-8

Tested T3.5 Serial1-6

T3.6 - Added support for LPUART which is Serial6 which now works.

T-LC
Make half duplex work on T-LC on Serials1-3

Tested on on T3.5 1-6

Additional PR for SERIALX_DISABLE follows

With the new beta boards, for those users who don't need an SDCard for
their project, it would be great to allow them to use the 6 IO pins
associated with the SDCARD for other purposes.  This would probably
require a cheap adapter, but these are nice signals to be able to be
used.  They include:

SPI1: SCK, MISO, MOSI, CS0-2
Serail2: TX/RX
Serial4: TX/RX
I2C1: SCL/SDA

This change adds support for GPIO, SPI, Serial2 and Serial4

The T-LC and the new beta boards T3.6 and soon T3.5 hardware uarts have
ability to turn on 2 stop bits.  So enabled on these boards.

On T3.2 if you do something like:
Serial2.setTX(31);
Serial2.setRX(26);
Serial2.begin(.9600);
...
Serial2.end();

It will on the end call will always reconfigure pins 9 and 10 to be
digital pins MUX = 1

These two functions were checking (SIM_SCGC4 & SIM_SCGC4_UART2)
and should be testing (SIM_SCGC4 & SIM_SCGC4_UART1)

Updated Serial2.
It had valid TX for T3.2 of 10 and 31, but 31 on T3.5 is RX4

Likewise RX for T3.2 of 9 and 26, but on T3.5 26 is RX1

https://forum.pjrc.com/threads/29446-Teensy-Hardware-Flow-Control-RTS-CTS?p=80425#post80425

https://forum.pjrc.com/threads/27093-Fix-for-9-bit-serial-receive-bug

https://groups.google.com/a/arduino.cc/d/msg/developers/ls3hkviFYM4/XWT2LbfzNcgJ

http://forum.pjrc.com/threads/26064-Large-transfers-over-serial-on-Teensy-3-1
http://forum.arduino.cc/index.php/topic,165574.0.html