Serial8 is now defined for T4.1.

Previously it was defined for T4B1, but went away on T4B2 and released.  It is now defined on the T4.1

rx_pins should depend on cnt_rx_pins not cnt_tx_pins, currentlty the same so does not impact

This cut down some timings in yield.

Found some of our code has these defined, plus had in another test sketch so defined them hopefully with C bindings, but calls Serial1 object code

Fixed the Serial2 object to use the new correct pins, plus made Serial8 only valid for T4 B1 (not B2).

Also I defined IO pins for the six signals associated with the SD Card slot.

I have tested these both as IO pins and now as SPI2

Add some support for serialEventX calls when yield is called.

Currently keep table of which SerialX objects are Used (.begin called) and each has their own function which does the
if (Serial1.available()) serialEvent1();

Calling SerialX.end(), removes the call from the list.  Also the default weak pointer serialEventX functions call the disable function, as to only be called once as no one is actually processing them...

At some point will integrate this with EventResponder

Put in first pass at SerialX.end(),
Which should disable the Serial object, and I believe set the IO pins to be GPIO pins.

Also defined the extern void SerialEvent1() like functions in header in preperation for callbacks...

More support put in.

Now support for different formats of output.
So far I have tried 8N1, 8N2, 7E1, 7O1...

Fleshing out some of the missing pieces. - Need to test
copy NVIC execution priority from T3
Set priority per Serial object

RTS pin
CTS pin - only Serial3 supports
setRX, setTX - do nothing none of these have two pins defined.

Maybe temporary - but added from previous code ability to add second buffer for RX and TX

Used macros from OneWIre to fast set/clear the optional Transmitter Enable support.

Also fixed bug in ISR where was not properly looking for TC.  This will help make SerialX->flush() to work

This pass has some more support for using the Hardware Serial objects.

Including setting an ISR for doing both reads and writes,  sets up the FIFO,

Sitll lots more work to go.

Things like: fifo - need to better understand/set watermarks, also RX need to read in more than one byte if more available.

Also support fo r other features, like formats, 9 bit, ...

BUt at least you can do simple reads/writes

The T-LC and the new beta boards T3.6 and soon T3.5 hardware uarts have
ability to turn on 2 stop bits.  So enabled on these boards.

This is a WIP,  But I have now been able to create Serial6 on T3.4 beta,
and so far have tested Send/Receive basic stuff at 115200 and have tried
at several CPU speeds in MHZ (192, 216, 180, 120, 96)

https://forum.pjrc.com/threads/29446-Teensy-Hardware-Flow-Control-RTS-CTS?p=80425#post80425

https://groups.google.com/a/arduino.cc/d/msg/developers/ls3hkviFYM4/XWT2LbfzNcgJ

http://forum.pjrc.com/threads/26064-Large-transfers-over-serial-on-Teensy-3-1
http://forum.arduino.cc/index.php/topic,165574.0.html

http://forum.pjrc.com/threads/25494-Problems-with-HardwareSerial-Pointer-and-write