It never came up much with T4 as there were not really alternative pins...

But fixed and tested with simple sketch on T4.1 and simple jumper to TX and RX pins on memory chip locations

Serial8 is now defined for T4.1.

Previously it was defined for T4B1, but went away on T4B2 and released.  It is now defined on the T4.1

Fixed the Serial2 object to use the new correct pins, plus made Serial8 only valid for T4 B1 (not B2).

Also I defined IO pins for the six signals associated with the SD Card slot.

I have tested these both as IO pins and now as SPI2

Allow the user to call setTX with the one hardware pin, and hopefully allow them to turn on Open Drain mode or turn it back off.  I don't currently have any test cases that use this, so not sure how well it works.

Add some support for serialEventX calls when yield is called.

Currently keep table of which SerialX objects are Used (.begin called) and each has their own function which does the
if (Serial1.available()) serialEvent1();

Calling SerialX.end(), removes the call from the list.  Also the default weak pointer serialEventX functions call the disable function, as to only be called once as no one is actually processing them...

At some point will integrate this with EventResponder

Put in first pass at SerialX.end(),
Which should disable the Serial object, and I believe set the IO pins to be GPIO pins.

Also defined the extern void SerialEvent1() like functions in header in preperation for callbacks...

Hopefully will be able to get this such that only those objects that are used will be brought in by the system...

More support put in.

Now support for different formats of output.
So far I have tried 8N1, 8N2, 7E1, 7O1...

Fleshing out some of the missing pieces. - Need to test
copy NVIC execution priority from T3
Set priority per Serial object

RTS pin
CTS pin - only Serial3 supports
setRX, setTX - do nothing none of these have two pins defined.

Maybe temporary - but added from previous code ability to add second buffer for RX and TX

Put in code to read all of the current stuff in Receive queue on Interrupt..

Used macros from OneWIre to fast set/clear the optional Transmitter Enable support.

Also fixed bug in ISR where was not properly looking for TC.  This will help make SerialX->flush() to work

Wrong RX_Select value

This pass has some more support for using the Hardware Serial objects.

Including setting an ISR for doing both reads and writes,  sets up the FIFO,

Sitll lots more work to go.

Things like: fifo - need to better understand/set watermarks, also RX need to read in more than one byte if more available.

Also support fo r other features, like formats, 9 bit, ...

BUt at least you can do simple reads/writes