teensy-sdfat/SdFat/examples/ReadCsvStream/ReadCsvStream.ino

/*
 *  This example reads a simple CSV, comma-separated values, file.
 *  Each line of the file has a label and three values, a long and two floats.
 */
#include <SPI.h>
#include "SdFat.h"

// SD chip select pin
const uint8_t chipSelect = SS;

// file system object
SdFat sd;

// create Serial stream
ArduinoOutStream cout(Serial);

char fileName[] = "testfile.csv";
//------------------------------------------------------------------------------
// store error strings in flash to save RAM
#define error(s) sd.errorHalt(F(s))
//------------------------------------------------------------------------------
// read and print CSV test file
void readFile() {
  long lg = 0;
  float f1, f2;
  char text[10];
  char c1, c2, c3;  // space for commas.

  // open input file
  ifstream sdin(fileName);

  // check for open error
  if (!sdin.is_open()) {
    error("open");
  }

  // read until input fails
  while (1) {
    // Get text field.
    sdin.get(text, sizeof(text), ',');

    // Assume EOF if fail.
    if (sdin.fail()) {
      break;
    }

    // Get commas and numbers.
    sdin >> c1 >> lg >> c2 >> f1 >> c3 >> f2;

    // Skip CR/LF.
    sdin.skipWhite();

    if (sdin.fail()) {
      error("bad input");
    }

    // error in line if not commas
    if (c1 != ',' || c2 != ',' || c3 != ',') {
      error("comma");
    }

    // print in six character wide columns
    cout << text << setw(6) << lg << setw(6) << f1 << setw(6) << f2 << endl;
  }
  // Error in an input line if file is not at EOF.
  if (!sdin.eof()) {
    error("readFile");
  }
}
//------------------------------------------------------------------------------
// write test file
void writeFile() {

  // create or open and truncate output file
  ofstream sdout(fileName);

  // write file from string stored in flash
  sdout << F(
          "Line 1,1,2.3,4.5\n"
          "Line 2,6,7.8,9.0\n"
          "Line 3,9,8.7,6.5\n"
          "Line 4,-4,-3.2,-1\n") << flush;

  // check for any errors
  if (!sdout) {
    error("writeFile");
  }

  sdout.close();
}
//------------------------------------------------------------------------------
void setup() {
  Serial.begin(9600);
  
  // Wait for USB Serial 
  while (!Serial) {
    SysCall::yield();
  }
  cout << F("Type any character to start\n");
  while (!Serial.available()) {
    SysCall::yield();  
  }

  // Initialize at the highest speed supported by the board that is
  // not over 50 MHz. Try a lower speed if SPI errors occur.
  if (!sd.begin(chipSelect, SD_SCK_MHZ(50))) {
    sd.initErrorHalt();
  }

  // create test file
  writeFile();

  cout << endl;

  // read and print test
  readFile();

  cout << "\nDone!" << endl;
}
void loop() {}