Adding route() made me review dap_enable() more closely and it wasn't
doing what I intended to do before, it was ignoring I2S coming back from
Teensy, DAP was sourced from ADC as was I2S_DOUT and DAC was sourced
from DAP; Teensy received valid data from ADC but data from Teensy was
just discarded if user selected it.

Remove old version of AudioSynthWaveform. Fix sine wave generation to cl...

Fix #20

Play William Tell Overture using new AudioSynthWaveform

Add adc_hpf() to allow control of ADC high pass filter.

unsigned short .adc_hpf(uint8_t bypass, uint8_t freeze);
unsigned short .adc_hpf(uint8_t bypass);
bypass & freeze as defined on page 34 of the SGTL5000 datasheet.

Actual fix for multiple filter sets in AudioFilterBiquad

I am tired of seeing Serial.begin(9600); where 9600 is not going to be
used at all. Can Serial.begin(Serial.baud()); be acceptable?

Untested, will test it personally in next couple of days but sincerely
expect it will work so committing.

Todo: Test properly. Improve comments and possibly link to wiring
example(s).

modified an older 'detached' copy of the example source to try multiple
filters out and didn't notice the old comments till reviewing later.

Simplistic visual peak meter just outputs to terminal.

My manipulation of the contents of *data instead of the value of data
itself was foolish at best - forgot to leave the * off for my intent.

fixed updateCoefs(..) for other than set 0 coefficients

While trying to find why assigning more than one set of coefficients for
AudioFilterBiquad results in no output I discovered my check for flag
before updating other than 1st set of coefficients was flawed so I fixed
it.

I also modified the way 'data' is assigned so the assignment only occurs
once per set of coefficients, possibly not the most efficient but I like
it better than my previous method.

These changes don't appear to effect the use of AudioFilterBiquad for a
single set of coefficients and, unfortunately, it doesn't make it start
working either - implementation of a second (or more than one) set of
coefficients still results in output being silenced but the update to
updateCoefs(..) is necessary so I am committing it.

deadly simplistic peak difference measuring object, after begin() just
goes through samples and find the maximum and minimum signed values,
natural behavior of begin() is to reset the max and min, member uint16_t
Dpp() returns maximum difference seen and .stop() does what it says.

fix for compounding/cascading filters

I put the line I had moved into the loop the wrong side of the test
conditional.

I left 'end' in an undefined state before.

'data' needs to be reset inside the 'flag' controlled loop or
*undefined* behavior is likely when user sets 'flag' and loop repeats
without resetting 'data' to beginning of block.

adding surround and bass enhance controls

added last of dap 'bits' to control_sgtl5000.* and include an example
for bass enhance, need to make one for surround stuff.

Cosmetic fixes to chorus and flange examples and synth_tonesweep (ignore AudioSynthToneSweep changes)

Add AVC control to control_sgtl5000.* and example