The pins were not in the table before...

rx_pins should depend on cnt_rx_pins not cnt_tx_pins, currentlty the same so does not impact

This cut down some timings in yield.

Add quick test at start of function to return if there are no events pending.

Do this before checking if in ISR and the like.  Cut timing down a lot in yield.

Found some of our code has these defined, plus had in another test sketch so defined them hopefully with C bindings, but calls Serial1 object code

Put in probably temporary bandaids to allow code that uses:
Serial.readBytes(Buffer, cnt);

To function.  It simply loops calling the underlying code for Serial.read().

Comment out some of the main programs debug print statements plus add yield call to main loop.

yield can now call SerialEvent.

Put hack in that if the user has not overwritten the SerialEvent function, the weak linked one will turn off calling itself...

The B2 board has different IO pins here for these two pins

Saves power and prevents heating

todo:
analogInputToDigitalPin(p)
digitalPinHasPWM(p)

Fixed the Serial2 object to use the new correct pins, plus made Serial8 only valid for T4 B1 (not B2).

Also I defined IO pins for the six signals associated with the SD Card slot.

I have tested these both as IO pins and now as SPI2

Moved from my flexio_t4 library.
Libary was updated to see if already defined before it now defines it.