An experiement to see how much work again it would take to add the T4 methods to allow user sketches to increase the size of Serial ports RX and TX buffers, without having to edit the Source code which does it then for all sketches.

T3.x SerialN Add extra memory capabilities for Serial1-6

Also

Fixed serialEventX yield handling when you call begin multiple times

There is an issue that if you are not using the serialEvent type code and you call SerialX.begin multiple times, it will add that item to the process list multiple times, which can overrun the memory and cause crash or the like.

Fix was to check the list first and see if we are already in the list.

Migrating the half duplex support I did in the Stagnant and out of date PR to enhance Uarts: https://github.com/PaulStoffregen/cores/pull/419

To try to support Half duplex mode in a similar way like we do for RS485 like support.

With T3.x made use of bitband address for the TX Direction setting, so
Except for the begin which calls format, no code changed, we simply stored the bitband address of the TXDIR flag into the TXDIR variable that was already used for the set direction flag.

For T4.x - it is a little more work as there is no bitband support on M7 processors.  For GPIO there is a Set and Clear register which we use, but for the appropriate UART register there is no such setup of registers.  So I have to special case we are in that mode and do it... Also since not atomic I cli/sei...

Serial Half Duplex - Fix T4Serial1 and T-LC Serial1-3

Updates: T4
T4 Serial 1 did not have proper settings for IOMUXC_LPUART6_TX_SELECT_INPUT

Tested T4.1 Serial1-8

Tested T3.5 Serial1-6

T3.6 - Added support for LPUART which is Serial6 which now works.

T-LC
Make half duplex work on T-LC on Serials1-3

Tested on on T3.5 1-6

Additional PR for SERIALX_DISABLE follows

Needed to add new Define for clock gate

Plus defines to use the new clock gate, plus correct case name for the
serial6 isr to match what is in system isr table

The T-LC and the new beta boards T3.6 and soon T3.5 hardware uarts have
ability to turn on 2 stop bits.  So enabled on these boards.

This is a WIP,  But I have now been able to create Serial6 on T3.4 beta,
and so far have tested Send/Receive basic stuff at 115200 and have tried
at several CPU speeds in MHZ (192, 216, 180, 120, 96)

On Serial 3 this addition is for all 3.x.  Before it was ifdefed to only
do work on Teensy_LC as there is only one valid TX pin.  But we now pass
in open drain as an option so this code should allow you to not turn it
on/off on Serial3 on all of these boards

and on Serial4 and Serial5 on the new boards.

https://forum.pjrc.com/threads/29446-Teensy-Hardware-Flow-Control-RTS-CTS?p=80425#post80425

https://forum.pjrc.com/threads/27093-Fix-for-9-bit-serial-receive-bug

https://groups.google.com/a/arduino.cc/d/msg/developers/ls3hkviFYM4/XWT2LbfzNcgJ

http://forum.pjrc.com/threads/26064-Large-transfers-over-serial-on-Teensy-3-1
http://forum.arduino.cc/index.php/topic,165574.0.html